摘要:
A method and apparatus for performing a serving high speed downlink shared channel (HS-DSCH) cell change from a source cell to a target cell are disclosed. A radio network controller (RNC) may pre-load a wireless transmit/receive unit (WTRU) with HS-DSCH configuration for the target cell. The WTRU receives and stores the pre-loaded HS-DSCH configuration. The WTRU may start monitoring a high speed shared control channel (HS-SCCH) on the target cell using the pre-loaded HS-DSCH configuration for the target cell on a condition that a measurement report is triggered by the event 1D. The WTRU may initiate a timer when the WTRU starts monitoring the HS-SCCH on the target cell and stop monitoring the HS-SCCH on the target cell upon expiry of the timer.
摘要:
A method and apparatus for segmenting medium access control (MAC) service data units (SDUs) creates enhanced MAC-es PDUs in the enhanced MAC-e/es sub-layer by concatenating MAC SDUs received from the logical channels. An enhanced transport format combination (E-TFC) selection entity controls the concatenation of MAC SDUs into enhanced MAC-es PDUs. When a MAC SDU is received that is too large to fit into a selected enhanced MAC-es PDU payload, a segmentation entity segments the MAC SDU such that the MAC SDU segment fills the remaining payload available in the selected enhanced MAC-es PDU. The enhanced MAC-es PDU is then assigned a transmission sequence number (TSN) and multiplexed with other enhanced MAC-es PDUs to create a single enhanced MAC-e PDU that is transmitted on the E-DCH in the next transmission time interval (TTI). A HARQ entity stores and, if necessary retransmits the enhanced MAC-e PDU when a transmission error occurs.
摘要:
A method and apparatus for cell update while in a Cell_FACH state are disclosed. After selecting a target cell, system information is read from the target cell including high speed downlink shared channel (HS-DSCH) common system information. A radio network temporary identity (RNTI) received in a source cell is cleared and a variable HS_DSCH_RECEPTION is set to TRUE. An HS-DSCH medium access control (MAC-hs) entity is configured based on the HS-DSCH common system information. High speed downlink packet access (HSDPA) transmission is then received in the target cell. A CELL UPDATE message is sent to notify of a cell change. The HSDPA transmission may be received using a common H-RNTI broadcast in the system information, a reserved H-RNTI as requested in a CELL UPDATE message, or a temporary identity which is a subset of a U-RNTI. The MAC-hs entity may be reset.
摘要:
A method and apparatus for utilizing a plurality of uplink carriers and downlink carriers are disclosed. A wireless transmit/receive unit (WTRU) activates a primary uplink carrier and a primary downlink carrier and activates or deactivates a secondary uplink carrier based on a signal from a network or upon detection of a pre-configured condition. The WTRU may deactivate the secondary uplink carrier based on inactivity of the E-DCH transmission, a buffer status, a channel condition, or power constraints. When the secondary uplink carrier is activated, dedicated physical control channel (DPCCH) transmission may be initiated predetermined time periods prior to initiating E-DCH transmissions. The initial DPCCH transmission power may be set based on a DPCCH transmission power on the primary uplink carrier or to a value signaled by a network. A default grant value may be used for initial E-DCH transmission upon activation of the secondary uplink carrier.
摘要:
A method and an apparatus for providing control information for multi-carrier uplink transmission are disclosed. A wireless transmit/receive unit (WTRU) may set a happy bit for enhanced dedicated channel (E-DCH) transmissions on each uplink carrier considering aggregated transmission capability over all uplink carriers. The happy bit is set to “unhappy” if the WTRU is transmitting as much scheduled data as allowed by a current serving grant, the WTRU has enough power available to transmit at a higher rate, and total E-DCH buffer status (TEBS) requires more than a pre-configured period to be transmitted with a current effective data rate aggregated over all uplink carriers. The WTRU may send scheduling information including power headroom measured on the anchor uplink carrier and/or power headroom measured on the supplementary uplink carrier. For power headroom measurements, the WTRU may initiate a short-lived dedicated physical control channel loop on the supplementary carrier.
摘要:
A method and an apparatus for serving high speed downlink shared channel (HS-DSCH) cell change are disclosed. A wireless transmit/receive unit (WTRU) receives pre-configured serving cell information for a target cell. The WTRU reports a measurement report and starts monitoring a high speed shared control channel (HS-SCCH) on the target cell. The WTRU may receive an HS-SCCH order over the target cell and/or a radio resource control (RRC) reconfiguration message over a source cell indicating a serving HS-DSCH cell change to the target cell. The WTRU may act upon all information elements of the RRC reconfiguration message in case that the RRC reconfiguration message is received prior to the HS-SCCH order, and act upon the pre-configured serving cell information in case that the HS-SCCH order is received prior to the RRC reconfiguration message.
摘要:
A method and apparatus for radio link control (RLC) re-segmentation are disclosed. An original RLC protocol data unit (PDU) is generated from at least one RLC service data unit (SDU). The RLC PDU size is within a flexible maximum RLC PDU size. The original RLC PDU is stored in a retransmission buffer. If transmission of the original RLC PDU fails and the original RLC PDU size is larger than an updated maximum RLC PDU size, the original RLC PDU is segmented to segmented RLC PDUs. If transmission of one of the segmented RLC PDUs fails, the original RLC PDU may be re-segmented to smaller size RLC PDUs, or the segmented RLC PDU may be sub-segmented. Alternatively, the failed RLC PDU may be processes as an RLC SDU to generate encapsulating RLC PDUs for carrying the RLC PDU. Alternatively, an RLC SDU corresponding to the failed RLC PDU may be re-segmented.
摘要:
A method and apparatus are disclosed for selecting a channel for uplink communication includes determining whether a cell supports transmission over an enhanced random access channel (E-RACH) and selecting whether to send uplink communications over the E-RACH or a random access channel. A method for selecting a transmission time interval (TTI) for use on an E-RACH includes evaluating radio conditions measured at a user equipment and selecting a long TTI if radio conditions are bad and selecting a short TTI if radio conditions are good. Alternatively, the TTI can be selected based on an amount of data to be transmitted on the uplink. A user equipment, an integrated circuit, or a Node B can be configured to perform either method.
摘要:
A method and apparatus for cell update while in a Cell_FACH state are disclosed. After selecting a target cell, system information is read from the target cell including high speed downlink shared channel (HS-DSCH) common system information. A radio network temporary identity (RNTI) received in a source cell is cleared and a variable HS_DSCH_RECEPTION is set to TRUE. An HS-DSCH medium access control (MAC-hs) entity is configured based on the HS-DSCH common system information. High speed downlink packet access (HSDPA) transmission is then received in the target cell. A CELL UPDATE message is sent to notify of a cell change. The HSDPA transmission may be received using a common H-RNTI broadcast in the system information, a reserved H-RNTI as requested in a CELL UPDATE message, or a temporary identity which is a subset of a U-RNTI. The MAC-hs entity may be reset.
摘要:
A method and apparatus for transmitting and receiving common logical channel and dedicated logical channel transmissions via a high speed downlink shared channel (HS-DSCH) are disclosed. A medium access control (MAC)-hs entity generates a MAC-hs protocol data unit (PDU) carrying a MAC-c/sh/m PDU and/or a MAC-d PDU. A UE-specific HS-DSCH radio network temporary identifier (H-RNTI) may be used for the MAC-d PDU, and a cell-specific H-RNTI may be used for the MAC-c/sh/b PDU. Alternatively, a cell-specific H-RNTI and one of a cell RNTI (C-RNTI) and a universal terrestrial radio access network RNTI (U-RNTI) may be used in a Cell_FACH state. The logical channel type and identity may be inserted in a MAC-hs PDU header or indicated by a distinct H-RNTI. A logical channel type for common logical channels may be identified in a MAC-c/sh/m PDU header. The logical channel type and identity may be identified by a queue identity.
摘要翻译:公开了一种经由高速下行链路共享信道(HS-DSCH)发送和接收公共逻辑信道和专用逻辑信道传输的方法和装置。 介质访问控制(MAC)-hs实体生成携带MAC-c / sh / m PDU和/或MAC-d PDU的MAC-hs协议数据单元(PDU)。 UE特定的HS-DSCH无线电网络临时标识符(H-RNTI)可以用于MAC-d PDU,并且小区特定H-RNTI可以用于MAC-c / sh / b PDU。 或者,可以在Cell_FACH状态中使用小区特定H-RNTI和小区RNTI(C-RNTI)和通用陆地无线接入网络RNTI(U-RNTI)中的一个。 逻辑信道类型和身份可以被插入到MAC-hs PDU报头中或由不同的H-RNTI指示。 用于公共逻辑信道的逻辑信道类型可以在MAC-c / sh / m PDU报头中被识别。 逻辑信道类型和身份可以由队列标识来标识。